# channel-group deadbeef-ospf99-intSel_PolGrp vpcĪpic1# show running-config leaf 122 interface ethernet 1/81 # Command: show running-config leaf 121 interface ethernet 1/81 * Use the CLI & the APIC Admin UI to verify the description was successfully added to the desired physical interface(s).Īpic1# show running-config leaf 121 interface ethernet 1/81 ![]() * Use the iNXOS CLI commands to add the desired "description" for the desired physical interface. Steps to add a description using the CLI: The APIC CLI method is the most common and easiest way to add an "unique" description to a particular interface. ![]() Port 1/81 is a member of the Access Block of the Interface Selector "deadbeef-ospf99-intSel" Interface Ethernet 1/81 on the above switches Glossary of nodes and interfaces used for the following examples: ![]() Each method will add the description to interface in a slightly different way and may present a different expected result. ![]() The following information may not apply to earlier versions of the Application Policy Infrastructure Controller but methods mentioned in this technote should work with the most recent ACI releases.Īdding a description to an interface on a switch in ACI mode can be accomplished using various methods. The following technote is written against Application Policy Infrastructure Controller Version 2.2(1o). HOW TO CONFIGURE AN INTERFACE DESCRIPTION FOR A SWITCH IN ACI MODE?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |